Tap Replacement in Taigum
Swapping a tap in Taigum is work for a licensed plumber, because Queensland places the job on its regulated list. Housing here runs from the 1970s through to the early 2000s, so the original tapware has done decades of service. Plenty of it is now due for a new fitting rather than another repair.
If we're late, $100 comes off your bill
- Licensed and InsuredEvery job done by a licensed plumber. QBCC No: 15024607
- Fixed Quote FirstFlat-rate pricing, agreed before any work starts
- Lifetime Labour WarrantyBacked by our Fix-It-or-It's-Free guarantee (T&Cs apply)
- $0 Call-Out FeesNo extra charge for nights, weekends or public holidays
We handle tap replacement across Taigum and the neighbouring suburbs, from one worn laundry mixer to a full kitchen and bathroom set. A dripping spout is usually just a washer, and tap repairs in Taigum covers that smaller job end to end. When the body is corroded, the finish has failed or the mixer has simply had enough, a replacement is the better spend.
Mixer Taps and Separate Taps Compared
A mixer joins hot and cold water at a single spout, run from one lever or two handles, while separate taps keep the two supplies at their own outlets. Which style suits your sink comes down to what the old fitting leaves behind.
Hole layout
the replacement has to match the count and diameter of the holes already cut in the bench or basin.
Mounting
a fitting that sits on the deck is plumbed from below, while a wall type draws its water from pipes buried in the wall. Switching between them means opening up the wall or the basin.
Isolation valves
a small valve fitted to each supply line closes the supply to that fitting alone, without turning off the whole house.
Supply connections
the fittings beneath the bench are checked before the new tap is chosen, so everything lines up on the day.
Tap Washers, Whole Taps and the Licence Line
Only a licensed plumber can swap a tap out, and the QBCC uses exactly this job as its example of work outside the short list a home owner can do without a licence. The single exception sits inside the tap: anyone with the right knowledge may renew the washer or jumper valve, which the QBCC classes as unregulated. That small job still has to meet the standards.
From there, the paperwork goes one of two ways:
A like-for-like swap
counts as minor work. A QBCC licensee carries it out, and neither a permit nor a Form 4 applies.
Fitting a new fixture, or relocating one,
in a standing building is notifiable work. The plumber files a Form 4 with the QBCC inside 10 business days of completion.
Rentals add one more layer. A tenant wanting to fit a fixture needs written approval on a Form 23, and a refusal needs a proper reason. If a tenant fits something anyway, the owner has three options:
- treat the installation as a breach and try to resolve the dispute;
- accept it as an improvement;
- remove the fixture and recover the costs from the tenant.
Certification Rules for Replacement Taps
WaterMark certification shows a plumbing product meets the safety and fit-for-purpose requirements of the Plumbing Code. WELS, the Water Efficiency Labelling and Standards scheme, is what gives a tap its star rating and its water use figure. Both are required before any licensed plumber may legally fit it.
Two practical checks follow from that:
The listing
any online listing needs to show the WaterMark trademark, the licence number and product specification, then the WELS registration number or registered model name and its star rating. You can search either product database by model name before buying, and the seller can be asked for anything missing.
The star floor
Business Queensland sets 3 stars as the minimum for tap fittings and showerheads, and states the rule does not apply to renovations.
Like for Like or a New Tap Position
The price turns on the tap you choose and on four things beneath it. Whether the isolation valves and connections can serve again, whether the holes match the new tap, how much room there is to work beneath the sink or basin, and how many taps are being done. Moving the fitting to a different position adds the Form 4 lodgement fee, which the contractor pays and may pass on to the owner with admin costs.
Townhouses outnumber detached houses here at the last census, and their complexes were built to a single spec. Mixers in neighbouring units therefore wear out together, so a worn one in a kitchen often predicts the next. You get a fixed quote before any work starts.
Which Rental Taps Meet the Limit
Cold taps inside the home and single mixers are capped at 9 litres a minute. That is the test before the owner can charge a tenant for the whole water bill. With so many Taigum homes tenanted, the limit comes up often.
The limit reaches only these fittings:
- cold taps and mixers above a hand basin, a kitchen sink or a laundry trough;
- nothing else: the bath, the garden tap and taps serving a washing machine or a dishwasher sit outside the limit.
For proof, the Residential Tenancies Authority tells owners to keep copies of plumbing reports, receipts, packaging and warranties. For the wider charging rules, our taps and toilets page and the toilet installation guide cover the rest of the bathroom set.
How a Tap Replacement Works
- 1
Get in touch
Call (07) 3523 7121 or send a quick message about the job in Taigum, and we'll ask what we need to know.
- 2
We swap the fitting over
We shut the supplies at the isolation valves, unbolt the old tap, and check the holes, the mounting and the connections against the new fitting. Then we set and seal it, run the water, and test every joint before we clean up.
- 3
Sign off the quote
You'll see a fixed quote before any work starts, with flat-rate pricing and no hidden fees. The job starts when you're happy with it.
- 4
Pay once it's done
Pay by card or EFTPOS on site after the work's finished, or choose Fix now, pay later.
Plumbing job in Taigum?
$0 call-out fees, available 24/7, and same-day where we can.
Tap Replacement Questions
Call (07) 3523 7121Can I change a tap myself at my Taigum place?
No, the whole tap has to be fitted by a licensed plumber. The one piece a home owner may legally touch is the washer or the jumper valve inside the tap, which the QBCC treats as unregulated work. Even that small job still needs to comply with the standards.
What do WaterMark and WELS labels mean on a tap?
WaterMark is the certification proving the product satisfies the Plumbing Code. WELS is the registration scheme that gives a tap its star rating and water use figure. Both are required before any licensed plumber may legally fit it.
Can a tap be shifted to a different position?
Yes, though the job changes category. Putting a fixture somewhere new in a standing building counts as notifiable work, so a licensed plumber carries it out and lodges a Form 4 with the QBCC within 10 business days of finishing.
What flow rate do rental taps need in Queensland?
Nine litres a minute is the ceiling. Cold taps inside the home and single mixers cannot run faster than that before the owner can charge a tenant for the whole water bill. The bath, the garden tap and appliance taps sit outside the limit.
Can a tenant swap a tap in a rented Taigum home?
No, because a tap swap is regulated work, so the owner or manager books the plumber. A tenant wanting to fit any fixture needs written approval on a Form 23 first, and a refusal needs a proper reason.
Call Us About the New TapsWe'll call you back.
Ring (07) 3523 7121 and tell us what's wrong. You get $0 call-out fees, a fixed quote before any work starts and same-day where we can, 7 days a week.
To claim your $0 call-out fee, call (07) 3523 7121 today.